244 Woodcraft Birch Bark Roll Put in one big rod for a finish, and tie hard loops in the cords at this point. Then, using shorter rods, make a narrower part about eighteen inches high for a head. Finally, cover this head with a piece of brown khaki or canvas which should be decorated with the band’s colors and totem, either painted or done in beadwork, or in colored cottons that are cut out and sewed on (Cuts Nos. 3 and 4). It is well to add alsoa wooden hook for one’s watch (a and b, Cut No. 3) anda pocket for matches and money, etc., at night. The Indians often elaborated these beds to a great extent when in permanent camps. Each rod was selected, perfectly straight, thinned at the butt end, to be uniform, and an extra piece added at the bed, head and foot, to curl up as end- boards. That at the head was elaborately decorated with symbols in beadwork. The illustration (No. 5) shows a beautiful beaded bed-head in my possession; not only the head, but the edges all around, are bound with red flannel. When in use the bed is laid with the ends of the rods rest- ing on two 4-inch poles, which are set firmly twenty-six inches apart; and the bed is staked at the corners through the loops to hold it in place (Cut No. 6). Cut No. 7 shows a fine specimen of an Arapaho bed all ready for / = use. When we can get no poles, NeS The beaded head. we lay down a couple of boards or rods to carry the ends of the bed, and then dig the ground out in the middle. By means of two tall stakes the head part is held upright. When packed up the bed is rolled. It weighs about five pounds. Of course, you always need as much under you as over you. Couched on such a natural spring mattress as the wil- low bed you sleep in perfect comfort. No, 6, —~ — 7 ™ ) — | ne TTL NU,
Stránka:roll 1931.djvu/260
Z thewoodcraft.org
Jmenné prostory
Více
- Více
Možnosti stránky
Verze z 23. 8. 2018, 22:55, kterou vytvořil Keny (diskuse | příspěvky) (→Nebylo zkontrolováno: Založena nová stránka s textem „244 Woodcraft Birch Bark Roll Put in one big rod for a finish, and tie hard loops in the cords at this point. Then, using shorter rods, make a narrower…“)
(rozdíl) ← Starší verze | zobrazit aktuální verzi (rozdíl) | Novější verze → (rozdíl)
Tato stránka nebyla zkontrolována